| Q: I cannot access the camera from a web browser. |
| A1: |
The possible cause might be the IP Address for the camera is already being used by another device. To correct the possible problem, you need to first disconnect the camera from the network. Then run the PING utility (follow the instructions in Appendix B - PING Your IP Address). |
| A2: |
Another possible reason is the IP Address is located on a different subnet. To fix the problem, run the PING utility (follow the instructions in Appendix B - PING Your IP Address). If the utility returns “no response” or similar, the finding is probably correct, then you should proceed as follows: In Windows 95/98/2000 and Windows NT, double check the IP
Address of the camera is within the same subnet as your workstation.
Click “Start”, “Setting”, “Control Panel”, and the “Network” icon.
Select TCP/IP from the “Network” dialog box and from the “TCP/IP Properties” dialog box click “Specify an IP address”.
If the camera is situated on a different subnet than your workstation, you will not be able to set the IP address from this
workstation. To verify make sure the first 3 sections of the IP address of the camera corresponds to the first 3 sections of the workstation. Therefore the IP address of the camera must be set from a workstation on the same subnet. |
| A3: |
Other possible problems might be due to the network cable. Try replacing your network cable. Test the network interface of the product by connecting a local computer to the unit, utilizing a standard Crossover (hub to hub) Cable. If the problem is not solved the camera might be faulty. |
| △TOP |
|
 |
|
|
| Q: Why does the camera work locally but not externally? |
| A1: |
Might be caused from the firewall protection. Need to check the Internet firewall with your system administrator. |
| A2: |
The default router setting might be a possible reason. Need to double check if the configuration of the default router settings is required. |
| △TOP |
|
|
|
|
|
|
|
|
| Q: There is poor image quality, how can I improve the image? |
| A1: |
A probable cause might be the incorrect display properties configuration for your desktop. You need to open the Display Properties on your desktop and configure your display to show at least 65’000 colors for example at least 16-bit. Please note applying only 16 or 256 colors on your computer will produce dithering artifacts in the image. |
| A2: |
The configuration on the camera image display is incorrect. Through the Web Configuration Image section you need to adjust the image related parameter for improve images such as brightness, contrast, hue and light frequency. Please refer to the Web Configuration section for detail information. |
| △TOP |
|
|
|
|